TSM (Sodium bicarbonate) Series Air Classifier

  • Dry desulfurization process, simple and reliable, 365 days * 24 hours of operation.
  • Grinding and classifying integration, the required particle sizes can be obtained efficiently and flexibly.
  • Optimized crushing structure, low temperature rise.
  • HCl removal rate > 99%; SO₂ removal rate > 95%.
  • With power assist device, easy maintenance.
  • Used in the places of municipal waste incineration, hazardous waste incineration, sludge incineration, steel mills, etc.
, ,

MZ Vibration Mill

  • Suitable for grinding raw materials with Moh’s hardness below 9.
  • Compared with ball mill, higher grinding efficiency, small occupation.
  • Particle size can be adjustable by adjusting parameters such as grinding medium, amplitude, and frequency. The finer powder can be given in conjunction with classifier in series.
  • Suitable for powder mixing, surface coating.
, ,

MZ Herb Vibration Mill

  • Suitable for grinding high tenacity and fiber materials that are difficult to be ground.
  • Grinding is in fully closed state, free of dust, high collecting efficiency.
  • Grinding chamber with cooling jacket, operating at temperature of -30ºC～0ºC.
,

RLM Ring Roller Mill

  • Relying on the grinding roller orbital revolution and rotation on the grinding ring track to finish grinding.
  • Built-in classifying wheel, available D50:2～45μm.
  • Compared with Raymond mill or ball mill, finer powder, lower operating cost.
  • Suitable for ultra-fine processing of nonmetallic minerals such as calcium carbonate.
, ,

RTM Turbo Mill

  • Conic rotor and stator are installed, fineness and output can be controlled by adjusting the gap between the rotor and the stator.
  • The rotor and the stator are made of special wear-resistant steel and thus have long service life.
  • The linear speed of grinding rotor can be up to 130m/s, good grinding effect.
  • Suitable for depolymerizing nano and micron material.

ULMG Drying and Deagglomeration Mill

  • Integration of grinding and drying, high efficiency, low cost operation.
  • Operation temperature up to 400℃, insulation design to bearing.
  • Grinding elements are replaceable and can be selected based on different raw materials.
  • Built-in classifying wheel, oversize particle could be ground in circulation.
, ,

ULM Turbo Mill

  • Suitable for raw materials with Moh’s hardness lower than 3.
  • The grinding rotor comprises multi-layer grinding disc and several grinding blades, high grinding efficiency.
  • Durable alloy blade, replaceable.
  • Available D50:10-45μm.
, ,

CUM-L Wood Fiber Mill

  • Suitable for grinding of fiber materials such as Chinese herbal medicine and straw etc.
  • Available 80-200 mesh.
  • Finer powder can be given if to be used with classifier.
  • Negative pressure operation, friendly-environment.
, ,

CUM-F Hammer Mill

  • Selectable grinding discs, wide application, flexible match.
  • Sieve hole size 0.2mm-3mm.
  • Easy operation, disassembling and cleaning.
,

CUM-P Pin Mill

  • No sieve, smooth discharge, high capacity and low operation cost.
  • Single or double drive, high line speed, finer particle size.
  • Available D50:10-45μm.

CREATING THE FUTURE OF

ADVANCED MATERIALS WITH
POWDER TECHNOLOGY

Copyright © 2000 – 2022 ALPA. All rights reserved.